![]() Up under the sink is where the mounting bracket and screw/s are. Then slide the base plate if it has one and then the rubber oring seal.Install the threaded rod and leave a little loose too.There is no need to over-tighten the hoses, there is a rubber seal on them.Making sure that the blue hose which is cold goes on the cold side and red on the hot site. Remove the new tap from the box and screw the hoses into the base.It all comes down to you but this is the way I do it most times. Now there really isn’t an exact step here to move it.Open the mixer tap and drain any water out.Unless you are in a 2 story then open whichever are the lowest hot and cold taps. Normally they are the lowest points in the house. If you have a bath, open the hot and cold water taps to drain the lines out. ![]() What I am going to show will be a mixer on a kitchen sink. ![]() Size varies, you will see in the video what I mean
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |